I have no idea what that bsod, etc jargon is. This performs a “loopback” test where the serial signal should go out from the computer, through the short and back into the computer again. Standard DB9-DB9 straight through serial cable: See all ggperformanceny has no other items for sale. Learn More – opens in a new window or tab Any international shipping is paid in part to Pitney Bowes Inc. Open MiniTerminal as above in step 7,8. Wish more info was available on connectivity issues from EFI.
|Date Added:||26 May 2012|
|File Size:||46.84 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Please enter a valid ZIP Code. Be sure to have TunerStudio installed. Both using windows 7?
The following errors occurred with your submission. TunerStudio will detect something, but when I try to connect it fails.
MS3 and USB connection
You may need to enter a password. If tests A, B and C all pass but you are having problems with the tuning software, it is most likely a settings problem within the tuning software itself. Seller assumes all responsibility for this listing. However, it also picks up large amounts of electrical noise. If it has not, try the cable and CPU socket loopback tests.
Works flawlessy with ms1, microsquirt module, ms2 and ms3. Almost all reported user problems are actually a computer setup problem, so follow these steps to get your settings right. Be certain not to bend the pins. Get an immediate offer. I’ve tried two PCs now, one 64bit windows 7 the other 32bit, same result.
If you have a question, comment, or suggestion for this FAQ please post it on the forum. See terms – opens in a new window or tab. Blimey, how old is your workstation: You are covered by the eBay Money Back Guarantee if you receive an item that is not as described in the listing. I’ve had those before on other tuning platforms.
Megasquirt Support Forum (MSEXTRA) • USB-serial adapter compatability list (View topic)
I’ve Always used it from the start in 2o Maybe you could check with yours if this is the same. Ensuring there are no shorts underneath the board, re-connect your serial cable and apply power. Start TunerStudio or other tuning software. Use only these manuals http: All you have to do is reduce that certain value from driver settings as Tunerstudio guide says and you are set.
So before you get into a panic, go through steps here to establish the correct COM port, then load the firmware to your MS2. They float usb to share, original serial is fifo first in first out, no collisions ever usb should be fixed on anything past MSPNP v2 with 3. Is the MS end loose at all? Board index All times are UTC.
As long as it auto connects in a reasonable time that doesn’t concern me. As shown here this indicates the computer serial end is working ok. Learn more – opens in new window or tab Seller information ggperformanceny This works good for usb-serial commnuications with Cisco Console ports.
I get a driver error in windows. Get the item you ordered or get your money back.